The AMC595 is based on the Virtex UltraScale™ XCVU440 FPGA in FLGA2892 package with an on board Power PC PC2040. The AMC595 is compliant to the AMC.1, AMC.2, AMC.3 and/or AMC.4 specification.
The module allows an FMC module to be mated. However, the FMC module must not use the standard height connector and must have the mated height of 17.5 mm (SamTec partnumber SEAM-40-11.0-L (or S)-10-2-A on the FMC module, the standard FMC connector is SEAM-40-03.5-L (or S)-10-2-A). VadaTech will deliver any of its FMC modules that mate to the AMC595 with the modified connector height. Contact Sales for the ordering option.
The on-board, re-configurable FPGA which interfaces directly to the AMC FCLKA and TCLK AD via a Cross Bar MLVDS (CBS). The FPGA has interface to one DDR4, 64bit wide,with 8 GB total memory. This allows for large buffer sizes to be stored during processing as well as for queuing the data to the host.
The onboard quad core P2040 runs at 1.2 GHz with 1 GB of DDR3, 128 MB of Boot Flash,and a 32 GB SD Card. The PPC has x4 PCIe interface to the FPGA in addition to its local bus. The PPC has its dual GbE routed to ports 0 and 1 of the AMC via a mux to allow FPGA routing to the ports as well. Same applies to ports 2-3 (PPC SATA ports or directly to the FPGA via mux selection).
Key Features
Xilinx Ultra Scale XCVU440 w/ QorIQ PPC2040
8 GB of DDR-4 (single bank of 64-bits)
FMC support (with special connector)
Ideal for ASIC prototyping/emulation and 100G transponder/muxponder
