The VadaTech UTC013 is a 792W power module (available in 396W) for use in a μTCA chassis. The power module runs at 95% efficiency when running at maximum load. This results in over 752W available to the system. It is fully compliant with the MicroTCA.0 revision 1.0 specification; including dual-redundant I2C buses (IPMB-0).
The UTC013 is hot-swappable and fully redundant when used in conjunction with a second instance of the module. It provides power to the twelve slots, two MCHs (MicroTCA Carrier Hubs) as well as the CUs (Cooling Units).
Multiple temperature sensors are included on-board to monitor for over-temp conditions within the module. The current is continuously measured for each of the modules and reported to MCH for any fault.
Once installed in the system the firmware is upgradable via the shelf manager. The UTC013 can be configured to power and enable the modules without the presence of an MCH.
Benefits
DC PSU for MicroTCA (792W)
Very low ripple voltage
Support for power module redundancy
Efficient re-use of existing designs/components reduce costs
Electrical, mechanical, software and system-level expertise in house
Key Features
Double-module, full-size module per AMC.0
Dual DC input (–36V to –75V)
792W (available in 396W)
Modules can be turned on without an MCH
Available in UTCA.3 conduction cooled
Two banks of 256K Flash for redundancy
Hot swappable
Dual IPMI bus
32–bit RISC processor
Blue, red, amber and red LEDs
IPMI 2.0 and HPM.1 compliant
Menu driven software for ease of configuration
Current sensor per slot
External as well internal WDT
