The VadaTech UTC011 is a 241/460W power module for use in a μTCA ATR chassis (Conduction Cooled chassis). The power module runs at 84% efficiency when running at maximum load. This results in 200/400W (available to the system). It is fully compliant with the MicroTCA.0 revision 1.0 specification; including dual-redundant I2C buses (IPMB-0).
The UTC011 is fully redundant when used in conjunction with a second instance of the module. It provides power to the twelve slots, two MCHs (MicroTCA Carrier Hubs) as well as the CUs (Cooling Units, may not be present in the Conduction Cooled Chassis).Multiple temperature sensors are included on-board to monitor for over-temp conditions within the module. The current is continuously measured for each of the modules and reported to MCH for any fault. The firmware is upgradable via HPM.
Benefits
Wide array of power module options from VadaTech
Design utilizes proven VadaTech subcomponents and engineering techniques
Electrical, mechanical, software, and system-level
expertise in house
Key Features
Single module, full size module per AMC.0
Dual 10 to 36 VDC input for 241W option and 18 to 36 VDC input for 460W option
Support for power module redundancy and dual IPMI bus
32-bit RISC processor
Two banks of 256K flash for redundancy
Field upgradable
IPMI 2.0 and HPM.1 compliant
Without the presence of an MCH the modules can be turned on
Menu driven software for ease of configuration
Current measure for each module
External as well as internal WDT
