The VadaTech UTC010 is a 792W power module (available in 396W) for use in a μTCA chassis. The power module runs at 95% efficiency when running at maximum load. This results in over 752W available to the system. It is fully compliant with the MicroTCA.0 revision 1.0 specification; including dual-redundant I2C buses (IPMB-0).
The UTC010 is hot-swappable and fully redundant when used in conjunction with a second instance of the module. It provides power to the twelve slots, two MCHs (MicroTCA Carrier Hubs) as well as the CUs (Cooling Units). Multiple temperature sensors are included on-board to monitor for over-temp conditions within the module. The current is continuously measured for each of the modules and reported to MCH for any fault. Once installed in the system the firmware is upgradable via the shelf manager. The UTC010 can be configured to power and enable the modules without the presence of an MCH.
Benefits
Wide array of power module options from VadaTech
Modifiable to rugged conduction-cooled version
Design utilizes proven VadaTech subcomponents and engineering techniques
Electrical, mechanical, software, and system-level
expertise in house
Key Features
Single module, full size module per AMC.0
Dual -36VDC to -75VDC input, 792W (available in 396W)
Hot swappable with support for power module redundancy
Dual IPMI bus
32-bit RISC processor
Two banks of 256K flash for redundancy
Blue, Red, Amber and Green LEDs
Field upgradable
IPMI 2.0 and HPM.1 compliant
Without the presence of an MCH the modules can be turned on
Menu driven software for ease of configuration
Current measure for each module
External as well as internal WDT
Available in uTCA.3 Conduction Cooled version
